High-quality industrial food-grade grease/lubricant for lubricating the ball bearing of a honey extractor, 15 cc cup. Use it to get your honey extractor spinning smoothly again.

3 rubber feet to mount under the honey extractor, including nuts and washers. They help prevent the extractor from sliding and these extractor feet also protect the floor against scratches.

These feet are universal and fit almost all honey extractors that have a 6 mm hole in the legs. If there is no hole, or the hole in the honey extractor legs is too small, you can easily drill it yourself with a 6 mm drill bit and deburr with a 10 mm drill bit.

Protective cover for a honey extractor with a maximum diameter of 520 mm. The cover is teardrop-shaped so the crank handle also fits underneath. With this cover you keep the extractor clean for the next extraction run!

Kit to convert your manual honey extractor for electric drive. With this kit you can fairly easily turn your manual honey extractor into an electric extractor. The kit consists of:

• Control module for variable motor speed; also a transformer to 24 V
• 24 V motor, 120 W
• Gear reduction to achieve the right speed and torque

Outer shaft diameter 19.8 mm, inner shaft diameter 15.3 mm, shaft height 54.3 mm, shaft recess depth 20.8 mm, bolt spacing 80 mm.

Please note: this is really for the handy beekeeper! Installation and use are at your own risk! So far, everyone has managed to mount this motor.

Ball for the ball bearing in most honey extractors. This ball has a diameter of 12.7 mm and can sometimes get lost during cleaning and honey extraction. This ball is used in various honey extractor models.

Replacement ball for the ball bearing in BeeFun honey extractors. This ball has a diameter of 9.5 mm and can sometimes be lost during cleaning and honey extracting. The 9.5 mm ball is specifically designed for BeeFun honey extractors.

Ball for the ball bearing of most honey extractors. This ball has a diameter of 8 mm and can sometimes get lost during cleaning and honey extraction. The 8 mm ball is widely used in Lyson and Lega honey extractors.

Ball bearing for the larger Lega honey extractors. This bearing has a diameter of 28 mm and an inner diameter of 12 mm. Over time, the bearing may need replacing. We always recommend keeping a spare bearing in stock.

Replacement lid for a Lyson honey extractor with a 500 mm diameter. This half replacement lid has no handle.

Spare lid for a Lyson honey extractor with a diameter of 500 mm. This spare half lid has a handle.